Note: This product should be used with two 12V 24V 8000N 800kg 1800lbs electric linear actuators C and two hall effect sensors (Model: 0043019).Package Include:
1 x Synchronous Controller (One-Control-Two, For 2 Linear Actuator C)
1 x Control Handle
1 x Remote Control (CP-3L)
1 x User manual
If you want to use multiple linear actuators to raise and lower an equipment, for example two or four electric actuators. Since the high speed DC motors in electric actuators cannot run at exactly the same speed, so the movement speed of the electric actuator will also be different. When multiple electric actuators work at the same time, their actual speeds cannot be exactly the same. In this case, we can use a synchronous controller to operate multiple linear actuators to rise or fall synchronously. They work completely in sync without any difference.
If you want to use a synchronous controller to operate 2 or 4 linear actuators fully synchronously, you will need to add built-in Hall effect sensors to each linear actuator. And when you purchased Hall effect sensor along with linear actuator, we will install Hall effect sensor to linear actuator for you.
When 2 or 4 linear actuators are running together, Hall sensor will send Hall signals to the synchronization controller, and the controller will adjust the running speed of each linear actuator, so that all linear actuators run at the exact same speed.
It can operate two electric linear actuators C to run completely synchronously.
Wired control via a control handle.
Wireless control via a remote.
Three function buttons: Up, Down and Stop.
With reset button.
Working Voltage: DC 12V or 24V
Working Frequency: 433.92 MHz
Working Distance: 100m / 300ft (theoretically)
Rated current: 30A
Case size: 240 x 170 x 56 mm (9.5 x 6.7 x 2.2 inches)
Operating Temperature: -20°C ~ +70°C
1) Connect the positive pole of DC power supply to terminal + of the controller, and connect the negative pole of DC power supply to terminal – of the controller.
2) Connect red power cable and black power cable of two linear actuators to linear actuator terminals of the controller.
3) Connect four hall signal cables of two linear actuators to hall signal terminals of the controller.
Operation via the control handle:
Press the UP button of the control handle, two linear actuators extend outward at the same time, they will reach the maximum stroke at the same time and stop automatically.
Press the DOWN button of the control handle, two linear actuators retract inward at the same time, they will fully retract at the same time and stop automatically.
Operation via the remote control:
Press the button ▲ of the remote control, two linear actuators extend out at the same time, they will reach the maximum stroke at the same time and stop automatically.
Press the button ▼ of the remote control, two linear actuators retract inward at the same time, they will fully retract at the same time and stop automatically.
Note: During operation, you can also press the stop button to stop two actuators at the same time.
When this system has been running for a long time, if you find that they are no longer fully synchronized, you can use the reset button to reset the controller.
Operation: Press and hold the reset button, then press the UP button or the DOWN button of the control handle, let the linear actuator run from the beginning position to the end position, finally release the reset button.