Setting and Operation of the 3 Control Modes for Ordinary Wireless Switch RF Receiver with 2 Channels Relay Output
1) Setting Momentary mode: Press the learning button in the receiver 2 times, signal LED continuously flashes 2 times and then goes off.
The operation of Momentary mode with two-button transmitter:
Press and hold the button A on the transmitter: The relay 1 in the receiver is activated, and the device connected to the corresponding output terminals is turned on.
Release the button A on the transmitter: The relay 1 in the receiver is deactivated, and the device connected to the corresponding output terminals is turned off.
Press and hold the button B on the transmitter: The relay 2 in the receiver is activated, and the device connected to the corresponding output terminals is turned on.
Release the button B on the transmitter: The relay 2 in the receiver is deactivated, and the device connected to the corresponding output terminals is turned off.
2) Setting Self-locking mode: Press the learning button in the receiver 3 times, signal LED continuously flashes 3 times and then goes off.
The operation of Self-locking mode with two-button transmitter:
Press the button A on the transmitter: The relay 1 in the receiver is activated, and the device connected to the corresponding output terminals is turned on.
Press the button A on the transmitter again: The relay 1 in the receiver is deactivated, and the device connected to the corresponding output terminals is turned off.
Press the button B on the transmitter: The relay 2 in the receiver is activated, and the device connected to the corresponding output terminals is turned on.
Press the button B on the transmitter again: The relay 2 in the receiver is deactivated, and the device connected to the corresponding output terminals is turned off.
3) Setting Interlocking mode: Press the learning button in the receiver 4 times, signal LED continuously flashes 4 times and then goes off.
The operation of Interlocking mode with three-button transmitter:
Press the button A on the transmitter: The relay 1 in the receiver is activated, and the device connected to the corresponding output terminals is turned on.
Press the button C on the transmitter: The relay 1 in the receiver is deactivated, and the devices connected to the corresponding output terminals is turned off.
Press the button B on the transmitter: The relay 2 in the receiver is activated, and the device connected to the corresponding output terminals is turned on.
Press the button C on the transmitter: The relay 2 in the receiver is deactivated, and the device connected to the corresponding output terminals is turned off.