How to pair the transmitter to the receiver
1) Press the learning button once in the receiver, signal LED on the receiver flashes one time and then stays on, this indicates that the receiver enters the learning status.
2) Pair single-button transmitter: Press the button on transmitter, if the signal LED flashes one time, this indicates that the pairing is successful.
Pair two-button transmitter: Press the first button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the first button on the transmitter is successful. Then press the second button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the second button on the transmitter is successful.
Pair three-button transmitter: Press the first button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the first button on the transmitter is successful. Then press the second button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the second button on the transmitter is successful. At last press the third button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the third button on the transmitter is successful.
Pair four-button transmitter: Press the first button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the first button on the transmitter is successful. Then press the second button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the second button on the transmitter is successful. Then press the third button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the third button on the transmitter is successful. At last press the fourth button on the transmitter, if the signal LED flashes one time, this indicates that the pairing with the fourth button on the transmitter is successful.
3) Press the learning button in the receiver again for 1-2 seconds, signal LED turns off, this indicates that the receiver exits the learning status.
4) The receiver can learn several transmitters with different codes.
How to delete all transmitters codes stored in the receiver
Press the learning button in the receiver 10 times and then release the learning button, signal LED flashes 10 times quickly and then goes off, this indicates that all stored codes have been deleted successfully.