1 x 10W/18V polysilicon solar panel
1 x 11.1V/3A solar charge controller
1 x 12V/5600mAh lithium battery
1 x Waterproof case with waterproof connector
1 set of cable with waterproof connector
The working principle of photovoltaic system:
PV system/Solar system generate electricity from sunlight, or rather solar energy. The sun’s rays fall on the solar photovoltaic panels cell, creating DC electricity. Then through the solar charge controller to charge the battery or lithium battery.
It is important electric parts for transferring the sun light power into electrical power for your application.
Suitable for all kinds of small power appliances (such as emergency lights, advertising lights, traffic lights, household lights, electric fans), solar water pumps, solar street lamps, wireless control devices.
It can be used as an alternative charger for any 12V lithium battery or lead acid battery.
With 12V lithium battery and solar charge controller to form a solar power kit for home that can provide power for DC electrical equipments. Such as lights,lamp,LED lighting, wireless switches or radio receiver, RF remote controls or transmitters.
Portable Solar Panel or Photovoltaic Panel:
Max Power: 10 Watt
Max Output Voltage: DC 18V
Max Output Current: 500MA
Open Circuit Voltage: DC 22V
Short Circuit Current: 600MA
Power Tolerance: ±5%
Operating temperature: -10°C ~ +85°C
Size: 340mm x 220mm x 3mm
Polycrystalline Silicon Material.
Lightweight design, 3mm thick.
Waterproof laminated panel construction.
Includes 20CM cable with water-tight connectors.
2 year warranty.
High conversion rate, high efficiency output.
100% power output - clear sky midday sun with the panel fully tilted toward the sun's position in the sky.
70-80% power output - clear sky midday sun but with the panel laid flat.
40-60% power output - thin cloud, or intermittent small clouds.
10-20% power output - midday overcast sky or rainy conditions.
Solar Charge Controller:
Rated Voltage: 11.1V
Max Solar Panel Voltage: 30V DC
Discharge Cut-off Voltage: 9.6V
Charge Cut-off Voltage: 12.6V
Max Charging Current: 3A
Max Load Current: 3A
Static Current: ≤3mA
Charging Mode: PWM
Fully automatic operation
With charge LED indicator and power LED indicator
Three operating modes selectable: normally open mode, light control mode, light and timer control mode.
Comprehensive electronic protection: overcharge protection, over discharge protection, overload protection, short circuit protection, reverse polarity protection.
Over load protection: When the load current reaches 4.5A, the controller shuts down the load output after 5 minutes; when the load current reaches 9A or above, the controller shuts down the load output immediately.
Operating temperature: -30°C ~ +55°C
Size: 54mm x 69mm x 22mm
Rated Voltage: 12V
Rated Capacity: 5600mAh
Cell Type: 18650
Cell Number: 6
Discharge Cut-off Voltage: 9V
Charge Cut-off Voltage: 12.6V
Maximum discharge current: 9A
Cycle Life: More than 500 times
Connector: DC 5.5*2.1mm Male Plug and Female Plug
With over current, overcharge, over discharge, and short circuit protection
Size: 56mm x 40mm x 67mm
1. Connect the lithium battery to the controller as shown.
2. Connect the solar panel to the controller as shown.
3. Connect the load to the controller as shown.
Note: Disassembly sequence is reversed to wiring sequence.